Keston C36 Installation Manual download pdf (Page 4)

0. HANDLING INSTRUCTIONS

0.1 LIST OF CONTENTS

The Keston C36 Combi and C36P Combi are supplied almost totally pre-assembled. The units

use standard 50 mm muPVC (BS5255 and/or BSEN1566-1 and BSEN1329) pipe for the flue

and air intake systems. The boiler is packed in a single box without additional flue kit. All

additional components are packed inside the boiler cabinet itself. The following is a list of

components and their location in the boiler cabinet

Equipment List

Item Quantity Location

Wall Bracket Rawl Plugs 6 Inside accessories bag

Wall Bracket Wall Fixing Screws 6 Inside accessories bag

Wall Mounting Bracket 1 Secured to inside right

hand side of boiler case

Pre-Installation Jig Locator Cross 1 Secured to outside right

hand side of boiler case

Wall Mounting Bracket Nuts 1 Inside accessories bag.

Wall Mounting Bracket Washers 1+1 Inside accessories bag

50 mm muPVC Air/Flue Terminals 2 Inside accessories bag

Air Inlet Spigot (50 mm) 1 Inside accessories bag

Flue Outlet Spigot (50 mm) 1 Inside accessories bag

Air Inlet Spigot Gasket 1 Inside accessories bag

Air Inlet Spigot + Flue Outlet Spigot M6 Screws 4+2 Inside accessories bag

Cabinet Cable Entry Clamps 2 Inside accessories bag

Gas Isolating Cock with PTN 1 Inside accessories bag

Filling Loop Kit 1 Inside accessories bag

Outside Temperature Sensor 1 Inside accessories bag

Document List

Item Quantity Location

Boiler Warranty Registration Form 1 In document bag

Installation Template 1 In document bag

Remove the cabinet shell by removing the two retaining screws in the top of the cabinet and

the two retaining screws in the bottom of the cabinet.

0.2 RECOMMENDED HANDLING PROCEDURE

NB : The following lift operation exceeds the recommended weight for a one-man lift as

specified in the Manual Handling Operations 1992 Regulations.

For the carriage of carton it is recommended at least two people perform any lift. Clear the

carriage route of the carton from point of delivery to point of installation. Take care to avoid trip

hazards, slippery or wet surfaces and when climbing steps and stairs. Always use assistance

if required. If a sack truck is used it is recommended the carton is strapped to the truck.

For the unpacking of the appliance from the carton, it is recommended at least two people

perform any lift. It is recommended to cut the base end of carton and open the carton flaps.

Ensure the protective packing over the boiler tappings at the base of the boiler is kept in place,

then tilt the boiler forwards from its back onto its base and remove carton by sliding up over

the boiler. When lifting this appliance the back should be kept straight at all times. Avoid

twisting at the waist - reposition the feet instead. Avoid upper body bending when holding the

appliance and keep the boiler as close to the body as possible.

Before hanging the appliance on the wall it is best to store the appliance laid on its back with

the casing on. When ready to hang the boiler on the wall remove the casing and place to one

WD388/0/2004 The Keston C36 Combi & C36P Combi Boilers

Page : iii

1 2 3 4 5 6 7 8 9 ... 56 57

Comments to this Manuals

No comments

Keston C36 Installation Manual Page 4

Comments to this Manuals

Related products and manuals for Water heaters & boilers Keston C36